How to Build End of Heroes Zombinoid Agony Kit

By Home - Kotous Store | Published: 2026-10-21

Category: How-to Guides

Learn to assemble the palm-sized End of Heroes Zombinoid Agony model kit with practical steps, common mistakes, and tips for a clean build.

Quick answer

Assemble the End of Heroes Zombinoid Agony kit by organizing parts, using a hobby knife and nippers, and following the manual step-by-step. Sand nubs, dry-fit joints, and apply panel lining for a clean finish.

Why preparation matters more than speed

This kit is palm-sized and fully articulated, so parts are small and joints are tight. Rushing often leads to broken pegs or stress marks on the plastic. Taking time to prepare your workspace and tools prevents most beginner mistakes.

Because the model is small, nub marks are more visible. A clean cut with a sharp nipper and a quick sanding pass will make a big difference in the final look.

The trade-off: articulation vs. stability

Fully articulated models like this one offer great poseability, but the trade-off is that small joints can be fragile. If a joint feels too tight, do not force it. Gently sand the peg or apply a tiny drop of silicone grease to reduce friction without loosening the fit.

Conversely, if a joint is too loose after assembly, a drop of super glue on the peg (let it dry before inserting) can thicken it for a snug fit. This balance keeps the figure poseable without breaking.

Step-by-step assembly

Step 1: Prepare your tools and workspace: Gather a hobby nipper, a hobby knife, a sanding stick or fine sandpaper (400-600 grit), and a cutting mat. Work in a well-lit area. Sort the runners by part number before starting. Check that all runners and parts are present before cutting anything.
Step 2: Cut parts carefully: Use the nipper to cut each part away from the runner, leaving a small nub (about 1-2 mm) rather than cutting flush. This prevents stress marks and damage to the part. Never twist parts off the runner; always cut.
Step 3: Clean the nubs: Use a hobby knife to shave off the remaining nub, then sand the area with fine sandpaper to smooth it. Work gently to avoid removing too much plastic, which can create gaps. Sand in one direction and check the surface under good light.
Step 4: Dry-fit before gluing: Temporarily assemble the parts without glue to check alignment and joint fit. If a joint is too tight, sand the peg slightly; if too loose, thicken it with a drop of super glue and let it dry. Dry-fitting reveals issues before you commit to glue.
Step 5: Assemble in the manual's order: Follow the instruction manual step-by-step, starting with the inner frame and moving outward. Do not skip steps, as some parts are locked in by later pieces. If a part doesn't fit, stop and re-read the manual; don't force it.
Step 6: Apply panel lining (optional): Use a fine-tip panel liner or a wash to darken the panel lines. Apply a small amount and wipe away excess with a cotton swab. This adds depth without painting. Let the liner dry completely before handling the figure.
Step 7: Final pose and display: Once assembled, pose the figure slowly, supporting the joints. Avoid extreme poses that stress the small joints. Display on a shelf or in a display case away from direct sunlight. If a joint feels stuck, apply a tiny drop of silicone grease instead of forcing it.

Product facts

END OF HEROES ZOMBINOID AGONY: The End of Heroes Zombinoid Agony is a new palm-sized and fully articulated plastic model series. Its small scale means precise handling and careful nub removal are essential to keep the joints clean and functional.
END OF HEROES ZOMBINOID AGONY